Part 9: Automatic Malfunction Detection System - Goddess WFE 1036 M10 Instruction Manual

Automatic fully electronic washing machine
Table of Contents

Advertisement

Available languages

Available languages

PART 9: AUTOMATIC MALFUNCTION DETECTION
SYSTEM
Your washing machine is equipped with a system, which during the washing process continually monitors the
correct progress and in the case of any malfunction takes the necessary remedy measures and will at the same
time inform you about the malfunction.
Error code
E01
E02
E03
E04
(*) Check the information contained in chapter "MAINTENANCE AND CLEANING".
Possible cause
Open washing machine door.
The water pressure
or the water level
inside the machine
is low.
The pump is faulty
or pump filter is
clogged or electrical
connection of the
pump is faulty.
There is an excessive amount of
water in the washing machine.
Solution
Close the washing machine door. If the
problem continues, turn off the washing
machine, disconnect it from the power
socket and immediately contact the nearest
authorised service centre.
Turn on the faucet. Mains water
may be cut-off. If the problem still
continues, your machine will stop
after a while automatically. Unplug
the machine, turn off your faucet
and contact the nearest authorised
service.
Clean the pump filter. If the problem
persists, contact the nearest author-
ised service. (*)
Close the door.
If the problem persists, contact your nearest
authorised service centre.
EN - 23

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WFE 1036 M10 and is the answer not in the manual?

Table of Contents