Smart Diagnosis - LG VR637 Series Owner's Manual

Robot cleaner
Table of Contents

Advertisement

Available languages

Available languages

SMART DIAGNOSIS

Robot Cleaner uses this Smart Diagnosis feature to run a self-diagnosis.
If any irregularity is found from the diagnosis, please contact the local LG Electronics
service center.
※ During Smart Diagnosis, the Robot Cleaner will move about within a 50 cm radius. So, make
sure no objects are in the way within a 1 m radius around the Home Station, before starting
Smart Diagnosis.
1. Smart Diagnosis will operate when the main power
switch of the Robot cleaner and the Home station are
turned on, and the unit docked on the Home station.
※ Smart Diagnosis is only possible when the Robot
Cleaner is attached to the Home Station.
2. Press 'Diagnosis' button on the Remote Controller,
then the process will start with a voice message which
says "Robot Cleaner smart diagnosis will be started.
Please step away and clear around 1 meter around the
home station."
※ If the Mop Plate is attached, the process will not
be activated.
3. When the Smart Diagnosis has successfully
finished, Robot Cleaner will return back to the
Home Station and inform the result through
a voice message. After the voice message,
pressing the 'HOME' button on the Remote
Controller or main unit will allow the voice
message to be repeated. To terminate the
diagnosing process, press the 'Stop/OK' button
on the Remote Controller or main unit.
※ After the Smart Diagnosis voice message,
the Robot Cleaner will start recharging
after 1 minute.
※ If an error is detected with any of the
Sensors whilst in Smart Diagnosis, a
voice message will announce, and the
unit will not return to the home station.
Tip
• Be careful not to touch the Robot Cleaner or disturb its operation before Smart Diagnosis
is complete. If it is accidently interrupted, turn the main power switch OFF then ON again
to resume the diagnosis.
• Smart Diagnosis will not be activated in each of the following cases. In each case, check
the problem and try again.
- Robot Cleaner is detached from Home Station
- Battery level is insufficient
- No Dust Bin Filter is fitted.
- Mop Plate is attached
28

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vr626 seriesVr646 seriesVr627 seriesVr647 series

Table of Contents