LG VR637 Series Owner's Manual page 23

My Space Cleaning
Pressing 'My Space' on the Remote Controller
will set the My Space cleaning mode with a voice
message.
For cleaning of particular spaces, select this mode.
The 1st stage:
Use the Remote Controller to manually set the
parrameters of each cleaning block.
※ This cleaning mode will be accepted when the distance of the start and end position is less than
1 m in area.
The 2nd stage:
Pressing the 'Start' button will then make the Robot Cleaner clean the manually outlined area by
itself.
※ Upon failure to correctly outline a zone, a voice will announce, which says "Area does not meet the
specified conditions. Please continue to make specified area for cleaning process."
Use the Remote Controller to assign a zone, again.
※ Upon completion of cleaning for all selected areas, the Robot Cleaner will resume the cleaning
mode (Zigzag or Cell by Cell) which it was last set to.
Tip
• While recharging, you cannot activate 'My Space' mode.
• To change the cleaning mode while the Robot Cleaner is in operation, press 'Stop/OK'
button first then select a cleaning mode. The cleaning will then start from the begining.
CLEANING MODES
My Space
21