SI Nano Roll Installation Instructions Manual
Hide thumbs
Also See for Nano Roll:
- Installation instructions manual (20 pages) ,
- Installation instructions manual (20 pages) ,
- Manual operation instructions (16 pages)
Subscribe to Our Youtube Channel
Related Manuals for SI Nano Roll
Summary of Contents for SI Nano Roll
- Page 1 Nano Roll Installation Instructions Narrow Wirefree - Zigbee INSTALLERS: Please leave this manual with the owner. Doc. # 400091...
- Page 3 PARTS LIST - NANO ROLL (NARROW) - WIREFREE Shades (275 Roll) Charger Please note all the QR CODES on your Shade motors. See the last page on these instructions. Wall Brackets Spacer Blocks Leveling Shims (included) (included) Situo Remotes Ceiling Brackets...
- Page 4 NARROW SHADE - INITIAL CONSIDERATIONS 1a. Install 4 Spacer Blocks per bracket, to accommodate for external battery. Wall Mount only 1b. Install shade brackets at least 1” from back plane (glass or wall) to accommodate for external battery. Ceiling Mount only...
- Page 5 SPACER BLOCKS AND LEVELING SHIMS (OPTIONAL) Spacer Blocks - used to clear an obstruction in the fabric path. Connect spacer blocks to shade brackets before installation NOTE: Do not use more than 4 Spacer blocks per bracket. Leveling Shims - used if the window frame is out of level. Connect to shade brackets before installation NOTE: Do not use more than 2 leveling shims per bracket.
-
Page 6: Bracket Installation
BRACKET INSTALLATION 1a. Install the wall bracket / end cap assemblies with the supplied screws Wall Mount only 1b. Install the wall bracket / end cap assemblies with the supplied screws for Ceiling Mount Motor Use 1/4” magnetic Idler side side driver (incl.) Ceiling Mount only... - Page 7 MEASURE - NANO ROLL Measure the end cap to end cap width and verify it matches the ordered width. Adjust accordingly Brackets must be level before the shade is installed!
- Page 8 BATTERY INSTALLATION - WALL MOUNT 1. Install the external battery brackets to the dimensions listed below 2. Fasten each bracket with the included hardware (use drywall anchors if necessary) 3. Connect the magnet wire to the external battery and install into the brackets as shown below.
- Page 9 BATTERY INSTALLATION - CEILING MOUNT 1. Install the external battery brackets to the dimensions listed below 2. Fasten each bracket with the included hardware (use drywall anchors if necessary)
- Page 10 BATTERY INSTALLATION - CEILING MOUNT 3. Connect the magnet wire to the external battery and install into the brackets as shown below. 4. Install wire clips as shown (optional)
- Page 11 SHADE INSTALLATION - NANO ROLL 1. Remove the idler end cap with flat bladed screw driver 2. Insert motor side completely. NOTE: When installing, the shade should be at the upper limit.
- Page 12 SHADE INSTALLATION - NANO ROLL 3. Then, while supporting motor side, put idler end cap over the idler and snap into place. There will be an audible click.
- Page 13 CONNECT BATTERY - WALL MOUNT 1. Connect Shade to External Battery as shown below. NOTE: After connecting shade to battery, tuck wires up and away from shade.
- Page 14 CONNECT BATTERY - WALL MOUNT 1. Connect Shade to External Battery as shown below. NOTE: After connecting shade to battery, tuck wires up and away from shade.
- Page 15 PROGRAMMING - ZIGBEE PROGRAMMING STEPS (TaHoma/LinkPro Z must be plugged in and on the network) Step 1: Fine tune lower limit. Step 2: Assign shades to groups and remotes. Step 3: Pair devices and groups with remotes. The lower limit of every shade is preprogrammed to 1/2” from the bottom of the window. After installing each shade, follow these steps to adjust the lower limit: STEP 1 - Fine tuning lower limit : 1.
- Page 16 TROUBLESHOOTING - ZIGBEE Problem Possible Cause Action to Take For Zigbee Check network connection to the internet, and ensure TaHoma LED is Red. No internet the TaHoma is properly connected via ethernet or connectivity. Wifi. Check the battery level of a motor via the TaHoma Shade won’t operate.
- Page 17 NOTES...
- Page 19 MOTOR SERIAL NO.S Please keep a note of all the Serial No.s on your shade motors. OR for larger shade orders, refer to your Sales Order document for the list. Room Shade 1 Shade 2 Shade 3 Shade 4 Shade 5 Shade 6 Room Shade 1...
- Page 20 Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www.screeninnovations.com 400086 v. 1.3 13 November 2019...
Need help?
Do you have a question about the Nano Roll and is the answer not in the manual?
Questions and answers