Related Manuals for SI Short Throw Motorized
Summary of Contents for SI Short Throw Motorized
- Page 1 Short Throw Motorized Installation Instructions INSTALLERS: PLEASE LEAVE THIS MANUAL WITH THE OWNER. Doc. # 400280 | v. 1.0 | June 2024...
- Page 2 Limited 1 year warranty on Screen Innovations products Screen Innovations warrants its products to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. This warranty is limited to the original purchaser, provided that the product is used in accordance with our instructions and is not damaged due to improper handling, misuse, or neglect after shipment from the factory.
-
Page 3: Table Of Contents
Parts In The Box – Short Throw Motorized . . . . . . . . . . . . . . . . -
Page 4: Parts In The Box - Short Throw Motorized
PARTS IN THE BOX – SHORT THROW MOTORIZED Screen Remote Control Flown locking M5 X 10mm Locking plates (2) Plate Screw (4) 5x40 tapping screws (8) Flown Limit setting Floating Masonry Anchors (8) adaptor (2) tool (1) brackets(2) • Please ensure that the upper and lower mounting brackets are installed at the correct distance and in the correct position. -
Page 5: Wall / Ceiling Installation
WALL / CEILING INSTALLATION Before installation, determine the optimal mounting location for your cassette. For a secure and level installation, install the brackets between 1” and 8” from each side of the cassette. When ceiling mounting, it may be necessary to adjust the brackets by shimming one down to ensure proper alignment. -
Page 6: Ceiling Hanging Method
WALL / CEILING INSTALLATION To secure the casing, place the two ends of the casing flatly onto the bracket, ensuring proper alignment. Then, push the casing into the bracket until the locking tooth engages. You will hear a distinct locking sound when the casing is securely fixed onto the bracket. Once locked, tighten the lock screw to complete the installation. -
Page 7: Power Connect
Install the brackets onto the cassette and fully tighten the locking screws. See page 6 step 3. Note: Before operating, remove the weightbar retention stickers from the cassette bottom. POWER CONNECT The Short Throw Motorized screen includes a pre-wired NEMA AC plug. -
Page 8: Screen Control Instruction
SCREEN CONTROL INSTRUCTION Intelligent motorized screen has 4 control options: a) IR control b) Dry contact control c) RS485 or RS232 control d) Manual control (cycle control button) STOP DOWN Micro-up Micro-down a. IR Control - MI for IR: AC127/ -MF for RF: AC123 •... - Page 9 SCREEN CONTROL INSTRUCTION b. Dry contact control: Please check the wire and function in the below sheet and picture for RJ12 and RJ45: Wire Size Common Small Stop Down Cassette Wire c. RS485 or RS232 control: RS485 / RS232 port setting: •...
- Page 10 SCREEN CONTROL INSTRUCTION Hexadecimal control code: • Up: ff ee ee ee dd • Stop: ff ee ee ee cc • Down: ff ee ee ee ee • Some central control need to reset address code: ff ee ee ee aa Note: •...
-
Page 11: Maintain Screen
SCREEN CONTROL INSTRUCTION d. Manual control: The Manual Control button is located on the left side of the enclosure near the RJ45 connection. Stop Down Stop MAINTAIN SCREEN To enjoy the best viewing experience of your ST Motorized screen, please retract the Screen into the casing when not in use. - Page 12 Screen Innovations 9715-B Burnet Rd, Suite 400 Austin, TX 78758 512.832.6939 www.screeninnovations.com Doc. # 400280 | v. 1.0 | June 2024...
Need help?
Do you have a question about the Short Throw Motorized and is the answer not in the manual?
Questions and answers