Final Confirmation Of Install Completion - Defi -Link ADVANCE Control Unit SE Operation Manual

●Dip switch 1: Setting the buzzer sound ON/OFF.
●Dip switch 2: Select the opening/ending mode from A or B when the ignition is on/off.
⇒7. Part names / dimensions
<for customer and installation personnel>
⇒9.7.2 Set of warning buzzer ON/OFF
⇒9.3 Opening mode / Ending mode.
15. After setting is done, fix the control unit with attached nuts and bolts and commercial
mounting bracket.
Confirmation
Gauges, including this product, are not waterproof. Please do not install gauges near
the vehicle floor or in wet areas.
Do not use other than the supplied bolts. Use of other bolts may damage the inside of
the control unit.
Use mounting brackets with thickness of 3mm (0.1") and under.
It is possible to change the setting later. In order to change later, please fix the
control unit in the position you can reach so as to operate the dip switch.
The control unit contains buzzer. So it may difficult to hear the sounds if the control
unit is installed inside the dashboard or far from driver's seat.

8.3. Final confirmation of install completion

Warning
Please be sure to check the following list; otherwise, there is a possibility that a serious
accident may occur.
□Ensure that all hoses and tubing are permanently attached. Also ensure that there is no
liquid or exhaust leakage.
ADVANCE Control Unit SE Manual 22 Return to top