Klarstein HOT & HOT 10033534 Instructions Manual page 37

Problem
Burner will not light
using ignitor
(Electrical issues)
Burner will not match light
Sudden drop in gas
flow or low flame
Possible Reason
1. Electrode cracked or
broken;" sparks at crack."
2. Electrode tip not
in proper position
3. Wire and/or
electrode covered with
cooking residue.
4. Wires are loose
or disconnected
5. Wires are shorting
(sparking) between
ignitor and electrode.
6. Push button sticks at
bottom sparking between
ignitor and electrode
7. Wire insulation
might be broken
1. See "gas issues;"
on previous page.
2. Improper method
of match-lighting
1. Grease buildup.
2. Excessive fat in meat.
3. Excessive cook-
ing temperature
Solution
1. Replace electrode.
2. Tip of electrode should
be pointing toward
port hole in burner.
The distance should
be 1/8" to 3/16".
Adjust if necessary.
3. Clean wire and or
electrode with rubbing
alcohol and clean swab.
4. Reconnect wires or
replace electrode/
wire assembly.
5. Replace ignitor wire
6. Replace ignitor
7. Inspect wire insulation
and proper connec-
tion. Replace wires if
insulation is broken.
See "Pilot Gas Con-
trol Ignition" section
of use and care.
1. Clean burners and
inside of grill/ firebox
2. Trim fat from meat
before grilling.
3. Turn down the cook-
ing temperature
EN
37