Klarstein HOT & HOT 10033534 Instructions Manual page 32

EN
32
Vor der Inbetriebnahme
• The barbecue has to be installed on a secure level base prior to use.
• The barbecue shall be heated up and the fuel kept red hot for at least 30 min prior
to the first cooking.
• Do not cook before the fuel has a coating of ash.
• Do not use spirit or petrol for lighting or re-lighting! Use only firelighters complying
to EN 1860-3.
Lighting instructions
Warning
Danger of fatal burning
The lid must be open when lighting the burner!
Do not stand with your face directly over the gas grill when lighting
it.
Your gas grill will have following method of ignition.
Pilot Gas Control Ignition(Main burner or main burner with side burner or main
burner with side burner and back burner )
With all gas controls on the Gas grill in the "OFF" position " OFF", turn the gas
cylinder valve to the on position at the regulator. To create a spark you must press the
gas control knob (A) and hold in this position for 3-5 seconds to allow gas flow and
then turn anticlockwise to" HI" (B). It can spark to the burner lighting tube (C). You will
hear a "snap" from the igniter and you will also see a orange flame coming from the
burner lighting tube at the left side of the burner (D).
Continue to hold the gas control knob in for two seconds after the "snap", this will allow
gas to flow completely down the burner tube (E) and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are turned
to "HI". At "HI" setting the burner flame should be approximately 12-20mm long with
a minimum of orange flame. Turn the gas control knob fully anticlockwise for minimum
setting.
Should you have any difficulty lighting your gas grill following the above steps, contact
your dealer for advice.
If the automatic ignition can't be used, please remove the cooking grill and heat
diffuser(hotplate ), and turn the valve anticlockwise to 90° Cto light with BBQ lighter in
the distance of 5mm to the burner fire hole. Replace the cooking grill and heat diffuser
(hotplate), please wear the fireproof and heat resisting gloves.