Wipers And Washers - Honda Accord 2013 Owner's Manual

Hide thumbs Also See for Accord 2013:
Table of Contents

Advertisement

Main Menu
uuOperating the Switches Around the Steering WheeluWipers and Washers

Wipers and Washers

Pull to
use
washer.
Intermittent Time
Adjustment Ring
MIST
OFF
INT: Low speed with
intermittent
LO: Low speed wipe
HI: High speed wipe
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
140
Table of Contents
The windshield wipers and washers can be
used when the ignition switch is in ON
MIST
The wipers run at high speed until you release
the lever.
Wiper switch (OFF, INT, LO, HI)
Change the wiper switch setting according to
the amount of rain.
Adjusting the delay
Turn the adjustment ring to adjust the wiper
delay.
Long delay
Short delay
Washer
Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.
1Wipers and Washers
w
(
*1
.
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving, the
wipers make a single sweep.
When the vehicle speeds up, the wiper operation's shortest
delay setting ( ) and the LO setting become the same.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor is equipped with a breaker that may
stop motor operation temporarily to prevent an
overload. Wiper operation will return to normal within a
few minutes, once the circuit has returned to normal.
If the wiper stops operating due to any obstacle such as
the build-up of snow, park the vehicle in a safe place.
Rotate the wiper switch to OFF, and turn the ignition
switch to ACCESSORY
(
q
the obstacle.
or LOCK
*1
, then remove
(
0

Advertisement

Table of Contents
loading

Table of Contents