Main Menu
uuIndicatorsu
Indicator
Name
System
Message
Indicator
*
Turn Signal
and Hazard
Warning
Indicators
High Beam
Indicator
Lights On
Indicator
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
* Not available on all models
76
Table of Contents
On/Blinking
Comes on for a few seconds when you set
●
the power mode to ON, then goes off.
Comes on along with a beep when a
●
problem is detected. A system message on
the multi-information display appears at
the same time.
The turn signal indicators blink when you
●
operate the turn signal lever.
If you press the hazard warning button,
●
both indicators and all turn signals blink at
the same time.
Comes on when the high beam headlights
●
are on.
Comes on whenever the light switch is on,
●
or in AUTO when the exterior lights are
on.
Explanation
While the indicator is on, press the
●
(information) button to see the
message again.
Refer to the Indicators information in
●
this chapter when a system message
appears on the multi-information
display. Take the appropriate action for
the message.
The multi-information display does not return
●
to the normal screen unless the warning is
canceled, or the
button is pressed.
Does not blink or blinks rapidly - A
●
turn signal light bulb has blown.
Change the bulb immediately.
2 Replacing Light Bulbs P. 518, 520
—
If you remove the key from the ignition
●
switch
while the exterior lights are on,
*1
a chime sounds when the driver's door
is opened.
Message
*
—
—
—
—