Table of Contents
Advertisement
5. Cleaning Your Cooker
Fig.5-1
A
B
D
ArtNo.311-0032 Burner layout FSD
A – cap, B – head, C – notch, D – base , E – electrode
Fig.5-2
A
B
C
D
ArtNo.311-0033 Wok burner details FSD
E
A – inner burner cap, B – outer burner head, C – inner burner head,
D – outer burner head, E – wok burner base
Fig.5-3
ArtNo.311-0015 Burner alignment
Fig.5-4
A
ArtNo.311-0016 Fitting the burner inner head
A – electrode notch, B – ignition electrode
'D'
B
Essential Information
Isolate the electricity supply before carrying out any
thorough cleaning. Allow the cooker to cool.
C
Never use paint solvents, washing soda, caustic cleaners,
biological powders, bleach, chlorine based bleach
cleaners, coarse abrasives or salt. Do not mix different
cleaning products – they may react together with
hazardous results.
E
All parts of the cooker can be cleaned with hot soapy water
– but take care that no surplus water seeps into the
appliance.
Remember to switch on the electricity supply and reset the
clock before re-using the cooker.
We have developed a range of cleaning products that give
maximum performance without damaging the enamel and
painted surfaces. More information is available through either
the Cookware Collection brochure supplied with your cooker
or our website www.rangemaster.co.uk.
Hotplate Burners
Some models have a separate trim ring, which fits on the
burner head.
The burner heads and caps can be removed for cleaning.
Make sure they are absolutely dry before replacing them.
The Single Ring Burners
When refitting the burner head, ensure that the notch lines
up with the electrode or hole in the base. Check that the
burner head is level and that the cap is fitted centrally on the
burner head (Fig.5-1).
The Wok Burner
When reassembling the wok burner (Fig.5-2), turn over the
large base ring and find the 'D' shaped area (Fig.5-3). Turn the
head until the 'D' matches the one on the burner base. Flip
the burner over once again and place it on the burner base.
To fit the small inner burner, find the larger electrode notch in
the burner rim. Line this up with the white ignition electrode
and place the inner burner on the large base ring (Fig.5-4).
now fit the two burner caps, ensuring that they are seated
properly.
Check the burner ports are not blocked. If a blockage occurs,
remove stubborn particles using a piece of fuse wire.
Grill
The grill pan and grid should be washed in hot soapy water.
After grilling meats or any foods that soil, leave to soak for a
few minutes immediately after use. Stubborn particles may
be removed from the grid using a nylon brush. Alternatively,
the grill pan can be washed in a dishwasher.
Before you remove any of the grill parts for cleaning,
ensure that they are cool, or use oven gloves.
DO NOT use any abrasive substances.
12
Advertisement
Table of Contents
