Set Up The Router As An Access Point - TP-Link Archer AC2600 User Manual

Chapter 4
Note:
It may take 1-2 minutes to make the settings valid.
Tips:
• If your internet connection type is
• If you use Dynamic IP and
please go to Advanced >
• If you still cannot access the internet, refer to the
4. 3.

Set Up the Router as an Access Point

If you have another router, you can switch this new router to Access Point mode to
extend your existing network.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced
will reboot and switch to Access Point mode.
BigPond Cable, please go to
PPPoE and you are provided with any other parameters that are not required on the page,
Network > Internet to complete the configuration.
FAQ
> Operation Mode, select
Advanced > Network
section for further instructions.
Access Point and click Save. The router
Set Up Internet Connection
> Internet to set your router.
19