Table of Contents
Advertisement
4.3
Internal connectors
1.
Serial ATA connectors (7-pin SATA1–2 [Blue])
These connectors, controlled by Intel
cables for Serial ATA hard disk drives (SATA 5 connector for optical drive use by
default).
If the M.2 slot is occupied, the SATA6G_6 slot will be disabled.
2.
USB 2.0 connectors (10-1 pin USB56, USB78, Type A USB10)
The USB56 and USB78 connectors are for USB 2.0 ports. Connect the USB module
cable to the connectors, and then install the module to a slot opening at the back of
the system chassis. The USB10 connector is for a A-type internal USB 2.0 device.
The USB connectors comply with USB 2.0 specification that supports up to 480 Mbps
connection speed.
The USB port module is purchased separately.
4-10
®
C612 chipset, are for the Serial ATA signal
Chapter 4: Motherboard Information
Advertisement
Table of Contents
