Toshiba MMY-MAP1004HT5P Service Manual page 264

N . o P a t r o t b e e r p a l c e d
5 Reactor assembly
W o k r p o r
WARNING
Wear a pair of gloves.
Otherwise, you will risk an injury involving a
replacement part or some other object.
1. Detachment
1) Stop the operation, and turn off the circuit breaker.
2) Remove the inverter assembly.
(See the inverter assembly dismantling method
under item 4.)
3) With a 14, 16HP unit, remove the separately
mounted reactor box.
To remove the reactor box, remove the screws
at the top and bottom (M5 × 10) and unlock the
box by sliding the stopper to the right.
* Before pulling the reactor box, tilt it back to free
the bottom.
4) Remove the reactor box located at the back of the
inverter assembly.
(M4 × 6, 4 pcs.)
* The screws can be removed from the front.
With a 14, 16HP unit, remove the separately
mounted anchor plate.
(M4 × 6, 4 pcs.)
5) Remove and replace the reactor.
(M4 × 6, 1 pc.)
c e d u e r
[
– 263 –
R e m a k r s
• 14, 16HP case
3) Screw Fixing claw (slide stopper to right)
Screw
3)
Fixing claw (slide stopper to right)
4) Screws (2 locations)
4) Screws (2 locations)
• 8, 10, 12HP case
4) Screws (2 locations)
4) Screws (2 locations)