Sirius Satellite Radio SC-V1 User Manual page 18

figure 9 figure 9
mounting the Antennas on the Vehicle
Follow this procedure for mounting each antenna:
1. Select an appropriate mounting position for your type of vehicle according to the
instructions in the previous section.
2. Attach the rubber cover/tail to the antenna, as shown in Figure 10, and press the
antenna cable into the rubber cover/tail. The rubber cover/tail will help to position
the antenna the correct distance from the edge of the roof or trunk lid.
3. Clean the surface area of the vehicle where you will be installing the antenna with
the alcohol prep pad.
4. Peel the protective material from the adhesive strips (Figure 10) and press the
rubber cover/tail firmly into place on the vehicle (Figure 11).
[ ]

Installation
Protective Material
figure 10 figure 10
5. Double check that the location of the antenna and rubber cover/tail are correct,
and continue to press firmly down on rubber cover/tail for another 30 seconds.
At room temperature (68 degrees), maximum adhesion usually occurs within 72
hours. During this period, avoid car washes and other contact with the antenna
and rubber antenna cable cover/tail.
figure 11 figure 11
Repeat steps 1 through 5 for the second antenna.
Strain Relief
Adhesive Strips
Rubber Cover/Tail
Antenna Cable
[ ]
Installation