Water Supply Connection - Swann SW2050W User Instructions

As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows (refer to the plug wiring diagram).
The wire which is colored BLUE must be connected to the terminal which is
marked with the letter N or colored Black.
The wire which is colored BROWN must be connected to the terminal which
is marked with the letter L or colored Red.
The wire which is coloured GREEN/YELLOW must be connected to the
terminal which is marked E.
If a 13Amp (BS1363) plug is used, a 13Amp (BS1362) fuse must be fitted, or
if any other type of plug is used, a 13Amp fuse must be fitted, either in the
plug or adaptor, or on the Distribution Board.

Water Supply Connection

Inside the drum of the washing machine you will find water connection hose.
1) Connect the straight end of the hose to the cold water outlet at the
installation location. The outlet must be fitted with a ¾" threaded
connection. Ensure it is tightened adequately so that it does not leak.
Swan Helpline No. 0845 610 4118
5