Table of Contents
Advertisement
Installing your Skyway using the sticky pad dash mount
The sticky pad can be attached, removed, and reattached many times
without losing its adhesion, and should be safe to use on most surfaces
but please check before use.
Find a flat location on your dashboard where you can mount your
Skyway in a safe and convenient position and where it has an
unobstructed view of the road ahead. Remember, that you will need
to attach the power cable to the unit and plug the other end in to your
cigarette lighter/12V power socket, so find a position where this can
be done without obstructing or becoming a danger to the driver or
passengers.
The sticky pad should automatically stick wherever you put it, but this
will vary depending on the material and type of surface your dashboard
has. Only use the sticky pad if you are sure, it is not going to move
when driving.
Once you have found a suitable location for the sticky pad and have
checked that it will not move when driving, place the Skyway on to it.
The unit should not move from the pad when driving but double check
that it is secure before using.
Do not leave your Skyway or sticky pad on the dashboard when you
leave your vehicle in hot and sunny conditions.
Connecting to power
Attach the small end of the power cable to the 'DC in' socket on the
side of the unit. Insert the other end into an appropriate cigarette
lighter/12V socket in your vehicle.
User note. Do not attempt to power Skyway in your vehicle
using the USB cable or USB socket. A 5V USB power supply
will not provide adequate power to run Skyway and it will not
operate correctly. The USB socket and data cable is to be
used for updating the software and speed trap database only.
6
Advertisement
Table of Contents
