Advertisement
Set up temporary Guide
Clamp a temporary guide to the workpiece to make a
straight cut which is not parallel to edge of workpiece.
1. Clamp a suitable straight board across
workpiece parallel to desired location of cut.
2. Loosen Edge Guide Knob, then install Edge
Guide with Fence facing outward and up.
3. Tighten Edge Guide Knob securely.
4. Measure proper distance from bit to Fence.
5. Loosen Fence Knob, adjust
Fence, then tighten Knob.
template Guide installation
note: Template guide (sold separately) is for use with a
template on the workpiece only. Remove the Template
Guide when using this product for any other application.
1. Turn Router upside down.
2. Install template guide in Base's opening with its
collar facing away from the Base. Secure with
threaded ring from the inside of the base.
3. Secure template (not included) to workpiece:
a. Determine template offset by subtracting bit
diameter from Template Guide outside diameter
and divide by two.
Example: Template Guide outside diameter
is 5/8", minus the bit diameter of 3/8" equals
1/4", divide by two equals 1/8" offset.
Item 58253
For technical questions, please call 1-888-866-5797.
edge
Guide
Fence
b. Secure template to workpiece using
appropriate offset from desired cut line.
note: If clamps are used to secure
workpiece, make sure they do not
interfere with Router while cutting.
4. Place Router on template with collar of
template guide against edge of template. Apply
light pressure to keep template guide flat against
template edge. Cut material along desired cut line.
edge Guide
Knob
Fence
Knob
Page 9
Advertisement
