Advertisement
circle cutting
Use the center hole in the Fence as a
pivot point when cutting circles.
1. Install Fence according to Set Up
Temporary Guide on page 9.
2. Loosen Fence Knob, set distance from center hole
in Fence to far edge of bit, equal to radius of circle.
3. Tighten Fence Knob.
4. Align center hole in Fence with center point of circle.
5. Drive a nail through center hole
to secure Fence in place.
adjusting cutting Depth
Set the depth of cut using the scale
marked on the side of the Router.
1. Open Lock Lever, then turn Depth Adjustment Knob
until bit is retracted within Base.
2. Place Base on a flat surface, then slide
Motor down in Base until tip of bit contacts
workpiece. Close Lock Lever.
Workpiece and Work area Set up
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
Page 10
For technical questions, please call 1-888-866-5797.
edge Guide
edge
Guide
Fence
3. The Depth Scale indicates starting position.
Starting position will vary depending on bit used.
4. Add desired depth of cut to starting
position. Example: If starting position
is 1/2" and desired depth of cut is 1/4",
correct adjustment on the scale is 3/4".
5. Open Lock Lever, then use Depth Adjustment Knob
to move Motor up until scale shows correct
reading; in this example 3/4". Close Lock Lever.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
5. Make sure there are no metal objects in the
wood which might make contact with the bit.
6. Refer to maximum cutting depth in
Specifications on page 7.
Knob
center
Hole
Fence
Knob
Item 58253
Advertisement
