Advertisement
Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO preVent SeriOuS inJury FrOM acciDentaL OperatiOn:
Make sure that the power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
tO preVent SeriOuS inJury FrOM tOOL FaiLure:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BeFOre eacH uSe, inspect the general
condition of the tool. Check for:
• loose hardware
• misalignment or binding of moving parts
• damaged cord/electrical wiring
• cracked or broken parts
• any other condition that may
affect its safe operation.
2. aFter uSe, wipe external surfaces
of the tool with clean cloth.
3. periODicaLLy, wear ANSI‑approved
safety goggles and NIOSH‑approved
breathing protection and blow dust out of
the motor vents using dry compressed air.
Page 12
For technical questions, please call 1-888-866-5797.
4. periODicaLLy, wipe the Collet, Collet Nut,
and router bits with a light oil to prevent rust.
5. Over time, if the performance of the tool diminishes,
or it stops working completely, it may be necessary
to replace the Carbon Brushes.
this procedure must be completed
by a qualified technician.
6.
WarninG! tO preVent SeriOuS
inJury: if the supply cord of this power
tool is damaged, it must be replaced only
by a qualified service technician.
Item 58253
Advertisement
