Electrical Considerations - Empire Comfort Systems White Mountain Hearth Tahoe DVCX42FP30P Installation Instructions And Owner's Manual

Direct-vent zero clearance gas fireplace heater

Hide thumbs

Table Of Contents

Table of Contents

All wiring should be done by a qualified electrician and

shall be in compliance with all local, city and state building

codes. Before making the electrical connection, make sure

that the main power supply is disconnected. The appliance,

when installed, must be electrically grounded in accordance

with local codes, or in the absence of local codes, with the

National Electrical Code ANSI/NFPA 70 (Latest Edition).

Millivolt System Valve Models

A factory installed junction box is located on the lower right side of

the fireplace. Wiring must be fed to the junction box and attached

to the receptacle that is provided. Leave approximately 6" of wire

in the junction box for connection.

Attach black wire to one side of the receptacle and white wire to

opposite side of receptacle. The ground wire should be attached

to the green (ground) screw.

Install the receptacle into the junction box. Attach cover plate.

IPI System Valve Models

Power for switched and live sides of receptacle must come from

the same power source. (One circuit breaker on main panel

must switch all power off.)

2. From the wall box to the fireplace a 3-wire conductor with

ground is recommended, however two 2-wire conductors with

grounds may be used in place of a 3-wire conductor with a

ground if the black wires from the thermostat and blower switch

are identified.

Two wall switches may be used to activate the receptacle plugs

independently.

BLACK

TO 120V

WHITE

CIRCUIT

BREAKER

GROUND

39634-2-0720