Connecting the Base Station
Power supply unit
with cord
(110 VAC/60 Hz)
1
Insert the
G
small plug on
cord into pho-
ne jack
Place cord in
G
the base cable
channel,
insert power
G
supply unit
into wall out-
let.
Key to register
additional
handsets/Page
handsets.
2
Insert plug on the telephone cord into telephone jack on
G
base unit (clicks into place),
Place cord in cable channel on the bottom of the base,
G
Insert other end of plug into telephone jack on the wall.
G
The installation of the base unit should allow at least 8 inches
G
between the base and persons to be in compliance with FCC
RF exposure guidelines
Only use the power supply unit included as indicated on the
G
underside of the base.
Use the telephone cord supplied. Do not use any old cords.
G
Do not use an outlet controlled by a wall switch.
G
Setting Up the Telephone
Telephone jack with telephone cord
3