Sherwood RD-6105 User Manual page 18

In Dolby Digital, Dolby Pro Logic II or
Dolby Pro Logic mode, adjusting delay
times of the speakers
• In case of Dolby Digital, Dolby Pro Logic II or Dolby
Pro Logic mode, when the distances from the prime
listening position to front left, center, front right, rear
left and rear right speakers are same, the basic settings
are as follows according to the surround modes;
- In the Dolby Digital mode,
Center delay time : 0 ms, Rear delay time : 0 ms
- In the Dolby Pro Logic II Music, Matrix or Custom mode,
Rear delay time : 0 ms
- In the Dolby Pro Logic II Movie, Dolby Pro Logic mode,
Rear delay time : 10 ms
• If the center or the rear speaker(s) is(are) not at the
same distance from the prime listening position as the
front speakers, increase or decrease the center delay
time by 1 ms for every about 30 cm(1 foot) it is closer
or farther away and increase or decrease the rear delay
time by 5 ms for every about 1~1.5 m(3~5 feet) it is
closer or farther away.
Check the delay time to be adjusted.
POWER DISPLAY SLEEP VIDEO1
1 2 3 VIDEO2
4 5 6 VIDEO3
7 8 9 CD
0
T.TONE P.SCAN TUNER
D.TIME
DSP MODE D.TIME ADJUST AUX
AUTO CH. SEL MUTE T.MON
CH. LEVEL MASTER VOLUME
REMOTE CONTROL UNIT RM-105
• The delay time will be displayed for 5 seconds.
• The corresponding delay time is displayed. The
center delay time can be adjusted in the Dolby Digital
mode only.
Downmixing into 2 front channels
• Allows the multi-channel DTS or Dolby Digital signals
to be reproduced through only two speakers or through
headphones.
• When the digital signals from the DTS or Dolby Digital
program sources are input in available surround mode,
press the STEREO button.
• "ST" and the DTS or Dolby Digital indicators light up,
meaning it enters the 2-CH downmix mode, and then the
discrete multi-channels(except LFE) are mixed down into
2 front channels.
Adjust the delay time.
• Each time this button is pressed in the Dolby Digital,
Dolby Pro Logic II or Dolby Pro Logic mode, the
delay time changes in regular intervals.
• If the delay time disappears, start from the step 17
again.
In Dolby Digital mode, repeat the above
steps 17 and 18 to adjust the rear delay
time.
• To cancel the 2-CH downmix mode, select the
desired surround mode with using the DSP MODE
button.
• When the playback of the source on the player is
stopped or interrupted, etc., the 2-CH downmix mode
is not canceled even though "ST" and the DTS or
Dolby Digital indicators go off.
• If the headphones are plugged and the SPEAKER
button is set to off while the digital signals from the
DTS and Dolby Digital program sources are being
input, it will enter the 2-CH downmix mode
automatically(but only the DTS or Dolby Digital
indicator lights up still) and if the headphones are
unplugged and the SPEAKER button is set to on in
the 2-CH downmix mode, it will return to the
previous mode.
1 9