Enjoying Surround Sound - Sherwood RD-6105 User Manual

ENJOYING SURROUND SOUND

• Surround sound effect will not work properly if the signal passes through a graphic equalizer.
Please refer to your equalizer operating instructions for guidance on switching off (or defeating) the equalizer.
Depending on the input digital signal
format, select the desired decoding mode.
1
Notes:
• Only when the digital input is selected as signal input for the input sources except TUNER, AUX and TAPE
MONITOR, the decoding mode can be selected.
• Noise may be generated at the beginning of playback and while searching during DTS playback in the IN-
AUTO mode. In this case, try playing in the IN-DTS mode.
Select the desired surround mode.
2
• Each time the DSP MODE button is pressed, the surround mode changes depending on the input signal format and
the selected decoding mode as follows:
When Dolby Digital signals are input in the IN-AUTO mode, one of the following modes can be selected
depending on the number of the recorded channels.
• Dolby Digital 5.1-channel sources: DOLBY DIGITAL
• Dolby Digital 2-channel sources: DOLBY PRO LOGIC II MOVIE, DOLBY PRO LOGIC, DOLBY PRO LOGIC II
MUSIC, DOLBY PRO LOGIC II MATRIX and DOLBY PRO LOGIC II CUSTOM
When PCM(2 channel stereo) signals are input in the IN-AUTO or IN-PCM mode, one of the following modes can
be selected :
DOLBY PRO LOGIC II MOVIE, DOLBY PRO LOGIC, DOLBY PRO LOGIC II MUSIC,
DOLBY PRO LOGIC II MATRIX, DOLBY PRO LOGIC II CUSTOM, MATRIX, CHURCH, THEATER,HALL and
STADIUM.
• When the analog input is selected as signal input and analog stereo signals are input, you can select the desired of
these above surround modes, too.
• However, when DTS signals are input in the IN-AUTO or IN-DTS mode, the DTS mode will be selected
regardless of using the DSP MODE button.
Notes:
• When the selected decoding mode is not matched to the input signal format, no sound is heard. Therefore, be sure
to select the required decoding mode and the available surround mode according to the input signal format.
• When the 6 CH DIRECT is selected as an input source, the decoding and surround modes cannot be selected.
• Each time the AUTO button is pressed, the decoding
mode changes as follows:
IN-AUTO : The input digital signal format(DTS,
Dolby Digital or
PCM(2 channel stereo), etc.) used by the
selected digital input source is detected
automatically to perform the necessary
decoding process for optimum surround
modes.
IN-DTS : The DTS signal processing is performed
only when DTS signals are input.
IN-PCM : The PCM signal processing is performed
only when PCM signals are input.
1 5