Table of Contents
Advertisement
Operating the appliance
en
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel ‹.
The indicator flashes. The machine is
paused and checks whether it is
possible to add laundry.
If the display ® goes out, it is possible
to add laundry. The door is then
unlocked and can be opened.
To continue the programme. touch ‹
again. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Follow the information on the display
panel.
It is possible to add laundry during
■
the sensoFresh î programme.
The load display is not active during
■
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the control panel ‹.
1.
Select another programme.
2.
And touch ‹ again.The new
3.
program starts from the beginning.
When cancelling programmes
Note:
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Switch the appliance on again if
necessary. The ® and î symbols will
34
flash. If the symbols are off, the door
can be opened.
Cancel the programme
For programs at high temperature:
Touch the control panel ‹.
1.
To cool the laundry: Select q Rinse.
2.
And touch ‹ again.
3.
For programmes at low temperatures:
Touch ‹.
1.
Select 0 Spin or p Empty.
2.
And touch ‹ again.
3.
When cancelling programmes
Note:
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Switch the appliance on again if
necessary. The ® and î symbols will
flash. If the symbols are off, the door
can be opened.
Programme end during rinse
hold
The ‹ indicator flashes in the display
panel, and the preset spin speed and
remaining programme length are
displayed for the selected programme.
Continue the programme by:
Touching ‹ on the control panel or
■
Changing the spin speed and then
■
touching ‹ or
Selecting the Less iron S setting
■
and then touching ‹ or
Turning the programme selector to
■
p Empty and then touching ‹.
Advertisement
Table of Contents
