Faults And What To Do About Them - Siemens WM14T790ES Manual

Indicator
o is lit up
E:60 alternating with
- 2b and End
E:35 alternating with
- 10
E:36 alternating with
- 10
Other indicators

Faults and what to do about them.

Faults
Water is leaking from the
machine.
Water not flowing in.
Detergent is not being dis-
pensed.
The door cannot be
opened.
The programme will not
start.
The drum briefly jerks or
judders after the pro-
gramme has started.
The washing water is not
draining.
Water is not visible in the
drum.
Cause/remedy
Too much foam has been detected and additional rinse cycles have been activated.
Add less detergent to the next wash cycle with the same load.
At the end of the programme.
Not an appliance fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Spin the laundry
again if necessary.
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service. ~ Page 43
The drain pump is blocked. Clean the drain pump. ~ Page 37
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 38
Switch off the appliance, wait for five seconds and then switch it on again. If the indi-
cator appears again, call the after-sales service. ~ Page 43
Cause/remedy
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the supply hose.
■
Will the programme start?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.~ Page 39
■
Is the supply hose kinked or trapped?
■
The safety function is active. Do you want to stop the programme?
■
~ Page 34
Have you selected $ (Rinse Stop = no final spin)? ~ Page 34
■
Can the door only be opened by the emergency release? ~ Page 39
■
If you switch to a different programme, the door will remain locked for a
■
short time until there is no longer any active oxygen in the drum.
Have you started the programme or selected Finish in-time?
■
Is the door closed?
■
Is the childproof lock activated? Deactivate. ~ Page 33
■
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
Have you selected $ (Rinse Stop = no final spin)? ~ Page 34
■
Clean the drain pump. ~ Page 37
■
Clean the drain pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Faults and what to do about them.
en
41