MG COMET EV 2023 Owner's Manual page 44

Driving and Controls
Preparation Before Entering "READY"
State:
•
Check that the hand brake has been
pulled.
•
Ensure that no barriers exist around the
vehicle.
•
Ensure that all windows and doors are
clean and transparent.
•
Check whether the tire conditions and
the inflation pressure are proper and
whether foreign matters exist.
•
Ensure that seats and rearview mirrors
are at proper positions. Adjust them if
necessary.
•
Fasten the seat belt and ask passengers
to fasten seat belts.
•
Release the hand brake before the
vehicle starts.
38
If Vehicle Cannot Enter "READY"
State
If the READY indicator on the instrument
panel does not illuminate, it indicates that
the vehicle has not entered the READY state.
Please check whether the power switch is at
the "ON" position and whether the brake
pedal has been pressed.
If there is no display on the instrument panel
when the power switch is at the "ON" or
"ACC" position, the 12V battery may not
have insufficient power. Therefore, charge
the 12V battery first. It is suggested to contact
the Aftersales Service Center for solution.
Notes
If the vehicle is not at the "READY"
state, please do not use the audio system,
lamps, A/C or other electrical equipment
for a long time. When leaving the vehicle,
please also shut down the electric
equipment. Otherwise, the 12V battery
will run out, causing the instrument panel
unable to display and the vehicle will not
enter the READY state.
Parking
•
Before getting off the vehicle, pull
handbrake&turn the power switch to
"LOCK" and pull out the key. Turn the
steering wheel till the steering wheel is
locked.
•
When parking on a ramp, pull the
parking brake as tightly as possible,
while pressing the brake pedal.
•
When parking the vehicle on one uphill
ramp, turn the front wheels away from
the road shoulder. When parking the
vehicle on one downhill ramp, turn the
front wheels towards the road shoulder.