Remove The I/O Board - Lenovo Yoga Slim 7 Carbon Hardware Maintenance Manual

Remove the I/O board

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the solid-state drive (SSD) " on page 32
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Disconnect the right fan cable from the system board and then release the EDP cable from the
cable guide.
Figure 11. Disconnect the right fan cable and then release the EDP cable
Step 3. Remove two screws and then remove the right fan.
Figure 12. Remove the right fan
Screw specifications
M2.0 x L5.0
Step 4. Disconnect the I/O board cable from the I/O board. Remove four screws and then remove the I/O
board.
Number of screws
2
.
Chapter 4 Removing a FRU or CRU
35