Squeegee Blade Check And Replacement; Tank And Vacuum Grid With Float Cleaning, And Cover Gasket Check - Nilfisk-Advance SC370 43B Instructions For Use Manual

Hide thumbs Also See for SC370 43B:
Table of Contents

Advertisement

INSTRUCTION FOR USE

SQUEEGEE BLADE CHECK AND REPLACEMENT

1.
Clean the squeegee as shown in the previous paragraph.
2.
Check the condition of the front (A, Figure 16) and rear (C) blades,
ensuring there are no cuts and tears; if necessary, replace them as
shown below. Check that the front corner (F) of the rear blade is not
worn; otherwise, turn the blade to replace the worn corner with one of
the three remaining intact corners. If the other corners are worn too,
replace the blade according to the following procedure:
Using the tab (G), release and remove the elastic strap (D) from
the fasteners (H), then turn or replace the rear blade (C).
Install the rear blade in the reverse order of removal. Fasten the
elastic strap (D) to the fasteners (H) starting from one side. To
make the fastening procedure easier, secure the fasteners one at a
time, by locking the strap before the fastener with one hand and
pulling it with the other hand.
Remove the fastening strap (B) by disengaging it from the
fasteners (J).
Replace (or overturn) the front blade (A), then reinstall the
fastening strap (B ).
3.
Install the squeegee (E, Figure 15) and screw down the knobs (D,
Figure 15).
4.
Connect the vacuum hose (B, Figure15) to the squeegee (C, Figure 15)

TANK AND VACUUM GRID WITH FLOAT CLEANING, AND COVER GASKET CHECK

1.
Push the machine to a level floor.
2.
Ensure that the machine is off.
3.
Turn the recovery tank lid (A, Figure17) 90 degrees position where it can be taken off from the recovery tank, and then take out the
float ball filter (B) from the recovery tank lid.
4.
Clean the recovery tank lid (A), recovery tank (C), clean solution tank(D) and the float ball filter(B). Empty the recovery tank with
the drain hose (D, Figure 11).
5.
Install the float ball filter (B) and the recovery tank lid (A).
6.
Inspect the integrity of the tank sealing strip.
NOTE
The tank sealing strip (E) produces the vacuum inside the tank when the vacuum motor works. The tank must
be sealed so it can effectively absorb the water from the ground to recovery tank.
23
ENGLISH

Advertisement

Table of Contents
loading

This manual is also suitable for:

50000627

Table of Contents