Table of Contents
Advertisement
FAN MAINTENANCE
1. Follow steps 1-11 on previous page to access fan.
2. Disconnect fan wires and ground wire.
3. Loosen 2 wing nuts on either side of fan.
4. Slide fan forward and lift out to remove.
5. Replace or service fan.
6. Reverse steps 5-1 to reinstall fan.
Regency GFI300L Gas Fireplace Inbuilt
Wingnuts
PRESSURE SWITCH REPLACEMENT
Before you start ensure all power is turned off.
1. Follow steps 1-11 on previous page to access pressure switch.
2. Disconnect wire leads and tubing on the switch.
NOTE: It is important to label wires and hose connections to ensure the
new switch is hooked up in the same manner.
3. Remove the two screws on the mounting bracket.
4. Slide switch out to the left side.
5. Remove switch and replace.
6. Reverse steps to complete installation.
maintenance
Remove 2 screws
29
Advertisement
Table of Contents
