Table of Contents
Advertisement
OPERATIONAL INSTRUCTIONS
USING THE FITNESS METER
POWER ON :
Move the pedals or press the button.
POWER OFF :
Automatically shuts off after four minutes
of inactivity.
MODE BUTTON:
Press to select display functions, including SCAN, TIME,
SPEED, DISTANCE, CALORIES, ODOMETER, and
PULSE.
Press and hold for two seconds to reset all functions to
zero, except ODOMETER.
FUNCTIONS:
SCAN:
Automatically scans each function of TIME, SPEED, DISTANCE, CALORIES,
ODOMETER, and PULSE in sequence, display changes every six seconds. Press and
release the button until "SCAN" appears on the display.
TIME:
Displays the time from one second up to 99:59 minutes.
SPEED:
Displays the current speed from zero to 999.9 miles per hour.
DISTANCE:
Displays the distance from zero to 99.99 miles.
CALORIES:
Displays the calories burned from zero to 999.9 Kcal.
The calorie readout is an estimate for an average user. It should be used only as a
comparison between workouts on this unit.
ODOMETER:
Displays the total accumulated distance you have traveled from zero to 999.9 miles. The
total accumulated distance is retained when the meter is turned off.
PULSE:
Displays your pulse rate in beats per minute. To display pulse, select the PULSE mode
and grasp the pulse sensors on the handlebar, one in each hand. The heart icon will begin
flashing when the FITNESS METER senses your pulse. Your pulse will be displayed
approximately five (5) seconds after the heart icon is displayed. If the heart icon does not
appear, relax your grip or change your grip on the pulse sensors.
NOTE: The pulse function is a great tool to optimize your workout, but should be used as
a reference only.
NOTE:
1. The meter will shut off automatically after four minutes of inactivity. All function values
will be kept. Press the button and hold it down for two seconds to reset all functions to
zero, except ODOMETER.
2. The ODOMETER will be reset to zero after batteries are removed for battery
replacement or storage of the unit.
HOW TO INSTALL AND REPLACE BATTERIES:
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AAA batteries (1.5V each), the batteries
are not included. Refer to the illustration to install or replace the
batteries.
NOTE:
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery
with another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according
to all state and federal laws and regulations.
5. Do not dispose of batteries in fire.
12
ODO
SCAN
CAL
SPEED
PULSE
DIST
TIME
AAA Batteries
Advertisement
Table of Contents
