Gaggenau 400 Series Use And Care Manual page 40

en-us Troubleshooting
Issue
Food remnants on dishware.
Detergent residue in the appliance Lid of the detergent dispenser is blocked by items of dishware and will not open.
40
Cause and troubleshooting
Dishware was placed too close together or rack is overfilled.
Arrange dishware with sufficient space in between.
1.
The spray jets must reach the surfaces of the dishware.
Avoid points of contact.
2.
Spray arm rotation of the lower spray arm is blocked.
Arrange dishware so it does not obstruct spray arm rotation.
▶
Spray arm nozzles are blocked.
Clean the Spray arms.
▶
Filters are dirty.
Clean the filters.
▶
→ "Cleaning filters", Page 34
Filters are inserted incorrectly and/or not engaged.
Insert the filters properly.
1.
→ "Filter system", Page 34
Twist filters into place.
2.
Selected wash cycle is too light.
Select a more intensive wash program.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 8
Dishware has been precleaned too intensively. Then the sensors choose a lighter
cycle. Stubborn remnants cannot be entirely removed.
Only remove large remnants of food and do not pre-rinse dishware.
▶
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 8
Tall narrow containers in corner areas are not rinsed out adequately.
Do not position tall narrow containers at too great an angle or in corner areas.
▶
Upper rack on right and left not set to same height.
Set the upper rack on the left and right to the same height.
▶
→ "Upper rack", Page 15
Arrange dishware in the upper rack so the tab collecting tray is not obstructed by
1.
dishware.
→ "Loading dishware", Page 26
Items of dishware are blocking the dispenser lid.
Do not place dishware or fragrance dispensers in the tab collecting tray.
2.