Synology NAS FS3410 Hardware Installation Manual page 16

5 Place the rear top cover back and slide it into secure position.
1 Align the hexagons at the side of the rear top cover with the slots on the chassis' edge, place it back and
push it to slide it back into position.
2 Put back and fasten the screw you removed in step 2.
To confirm that your FS3410 recognizes the new memory capacity
1 Install DiskStation Manager (DSM). Please see "Install DSM on Synology NAS" for more information.
2 Sign in to DSM as admin or a user belonging to the administrators group.
3 Go to Control Panel
If your Synology NAS does not recognize the memory or does not start up successfully, please make sure that
the memory module is installed correctly.
To remove the RAM Module
1 Follow steps 1 and 2 of the "To install the RAM module" section to shut down your FS3410, disconnect the
cables, and then remove the rear top cover as described above.
2 Cut the cable tie before removing the memory module. (The pre-installed memory module is cable-tied to
prevent it from loosening during delivery.)
Note:
Avoid touching any components on the motherboard when cutting the cable tie.
3 Push the retaining clips on the slot out to the sides. The memory module will pop out of the slot.
4 Follow step 5 of the "To install the RAM module" section to fasted the top cover back in place.
16 Chapter 2: Hardware Setup
> Info Center and check Total Physical Memory.