Standard Horizon EXPLORER GX1700E Owner's Manual page 22

25 watt vhf/fm marine transceiver
Hide thumbs Also See for EXPLORER GX1700E:
Table of Contents

Advertisement

5. Referring to illustration below, make a 30 mm hole in the wall, then insert
the Extension Cable into this hole. Connect the Gasket and Mount Base
to the Extension Cable Connector using the Nut.
6. Drill the four Screw holes (approx. 2 mm) on the wall, then install the
Mounting Base to the wall using four screws.
7. Put the Rubber Cap on to the Nut. The installation is now complete.
The routing cable can be cut and spliced, however care needs to be
taken when reconnecting the wires to ensure water integrity.
Before cutting the cable make sure it is not plugged into the radio.
After cutting you will notice there are the following wires:
Brown, Purple, Blue, Green, White
 The White and shield wires are wrapped in foil. Remove the foil,
and separate the White and shield wires.
Page 22
External Speaker Connections
Ferrite Core
Wall
Routing Cable
Mounting Bracket
NOTE
, Shield
Gasket
Cap
Nut
GX1700E

Advertisement

Table of Contents
loading

Table of Contents