Sharp 27F640 Operation Manual page 44

Operation of Universal Remote Control (Continued)
•
How To Identify a DVD
The remote control may already be set to
operate your DVD. Try this initial check before
going on to the following "identifying" section.
(1) Press CATV/DVD button.
(2) Point remote towards DVD and press POWER
(DVD/VCR).
(3) Does the Remote turn the DVD ON and OFF?
• If yes, the Remote is ready to operate the DVD
and no further steps are needed.
• If no, continue to the "identifying" section.
Setting Method.
Refer to the following steps and list to quickly
find the remote control code for your accessory
DVD.
• First look up your DVD's remote control code
number before going through the Setting
Method.
(1) Press CATV/DVD button.
(2) Press and hold down INPUT and CH
your remote control.
Then release both buttons.
(3) Within 10 seconds after releasing INPUT and
CH , enter your DVDs two-digit remote
s
control code number using REMOTE KEYPAD
(refer to the list).
• The remote control is now ready to send
commands to your DVD.
44
TV
POWER
DISPLAY
REMOTE
KEYPAD
POWER
(DVD/VCR)
on
s
CATV/DVD-
TV/VCR
INPUT
CHANNEL
UP (a)/
DOWN (s)
DVD BRAND
Denon
JVC
Magnavox
Marantz
Mitsubishi
Panasonic
Philips
Pioneer
Proscan
RCA
Samsung
Sharp
Sony
Toshiba
Yamaha
Zenith
Note:
Depending on the model, year produced,
brand, and type of DVD, some models may
not be compatible with the remote control.
REMOTE CONTROL
CODE NUMBER
02
09
04
04
06
02
04
08
03
03
07
01, 10
05
04
02
04