Heinner HWM-V7012D++ User Manual page 38

www.heinner.com
FAULT
Unsatisfactory washing
result.
Unsatisfactory
washing result.
As soon as the ma- chine
is loaded with water,
water dis- charges.
No water appears in
the drum during
washing.
Laundries have
detergent residues on
them.
Grey spots appear on
the laundries.
Spinning operation is not
performed or runs late.
POSSIBLE CAUSE
The contamination degree of
your laundries does not
match the programme you
have chosen.
Amount of detergent used
insufficient.
Laundries in excess of
maximum capacity put in
your machine.
Water being hard.
(Contaminated, lime water,
etc.)
Laundries distributed in your
machine non-
homogenously.
The end of water
discharging hose is too
low for the machine.
No fault. Water is in the
unseen part of the drum.
Non-dissolving particles of
some detergents may
stick to your laundries as
white spots.
The reason for such spots
may be oil, cream or
ointment.
No fault. Unbalanced load
control system has been
activated.
7Kg, 220-240V~50Hz, 1200rpm
TROUBLE- SHOOTING
Select the programme appropriate for
the contamination degree of your
laundries. (See programme table)
Adjust the amount of detergent based
on the amount and contamination
degree of your laundries.
Load your machine with laundries,
amount of which will not exceed
maximum laundry capacity.
Adjust the amount of detergent based
on the instruction of detergent
manufacturer.
Spread your laundries in the
machine properly and
homogeneously.
Set the water discharging hose on
appropriate height.
Perform an Extra rinse by setting your
machine to "Rinsing" programme, or
clean the spots using a brush after
your laundries dry.
Apply the maximum amount of
detergent instructed by the detergent
manufacturer in the next washing
operation.
Unbalanced load control system will try
to spread your laundries homogenously.
Spinning operation will begin after your
laundry is spread. Place the laundry in
the machine in a balanced fashion the
next time.
37