Table of Contents
Advertisement
6.3 FOR THE SELF-PROPELLED MOWER
To engage the self-propelled system, push the self-propelled lever on the handle (16) while maintaining
engaged with the brake lever.
16
To stop the mower, release
7. MAINTENANCE AND STORAGE
Before working on the cutting system of the machine, switch off the engine and remove the spark
plug's cap.
WARNING - Improper maintenance, use of nonconforming replacement components, or the removal or
modification of safety components can cause accidents and the deterioration of the tool.
a. Cleaning the mower
-
Cut grass is damp. Regular cleaning after each use will ensure better functioning of the mower and
reduce the risk of corrosion or seizure.
-
Having finished mowing, allow the engine to cool then remove accumulated grass clippings from and
around the engine with a brush.
-
Clean the grass collection bag annually with a brush or gentle spray of water.
-
Disconnect the spark plug's cap and tilt the mower on its side with the air filter and carburettor
uppermost.
-
Remove any remaining cut grass from the cutting system with a scraper and a brush.
-
Reposition the mower onto its four wheels.
-
Do not use a pressure washer or hot water to clean the mower. Be careful to avoid soaking parts such as
the engine, air cleaner, wheel bearings and metal fastenings. Dry off the machine before storing by
leaving it running for a few minutes on a flat, clear surface to prevent corrosion or seizure.
b. Blade maintenance
WARNING: Wear gloves, turn off the engine and remove the spark plug before proceeding.
The blade is made of hardened steel. To get a clean job, sharpen the blade frequently, about every 25
hours of use. Make sure the blade is always well balanced.
Insert a small iron pin (2 or 3 mm in diameter) into the hole in the middle of the blade: it must remain
the self-propelled lever
and then the brake lever.
17
16
Advertisement
Table of Contents
