Summary of Contents for Monte Carlo Fan Company ERA 3ERHR44 D Series
Page 1
Owner’s Guide and Installation Manual 3ERHR44XXXD Series Fan CUL Model NO. : 3ERHR44XXXD Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 7.1 kg 15.62 lbs Total fan weight with light...
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70), including fire-rated construction.
Page 3
Outlet box Before you begin installing the fan, Switch Before installing this fan make sure the Use metal outlet box suitable for fan power off at Service panel and lock outlet box is properly installed to the support and use only the screws provided service disconnecting means to prevent house structure.
Page 4
Black (Live) Ground/Green Blue White (Neutral) Ground/Green Mounting plate To Wall Outlet Box Ungrounded wires Grounded White wires Black Captured screw Blue After making the wire connections, the wires Lift motor assembly, aligning the should be spread apart with the grounded captured screws on the plate on top of conductor and the equipment-grounding fan assembly with the screw holes on...
Page 5
Blade Light fan Plate on motor Install blade with screws and washers Loosen 2 and remove 1 preassembled Connect the quick connector to the connector from the light pan. Be sure provided, aligning each of the holes as screw from the plate on motor. Save plugs connection clasped together firmly.
Page 6
Reverse switch Glass Attach glass by locating dimples in light Setting the reverse switch on the left pan with grooves on the glass and twist hand side will result in downward airflow clockwise until tight. and setting the switch on the right hand side will result in upward airflow.
Page 7
Wall Control Wiring, Installation and Operation Warning: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in order to avoid electrical shock. Note: Before installing the wall transmitter, place it in OFF position. (Fig.2) Make series-wound connection for the wall controller with HOT wire from house and lead wires from fan.
Troubleshooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning and lock the service panel to prevent the power from being switched back on accidentally. If the service panel cannot be locked to prevent the power from being switched on accidentally, securely fasten a warning sign to the service panel.