Table of Contents
Advertisement
DO NOT pull the shutter trigger without a camera installed. You
»
may accidentally detach or damage the control spring.
Troubleshooting
Water enters the housing
•
Check and reinstall the rear o-ring.
•
Replace the o-ring if there are any signs of cracks or tears.
•
Take the housing underwater to depth without a camera installed to
ensure that the leaking has been corrected.
Photos are over-exposed (too light)
•
Adjust aperture (smaller), shutter speed (faster), or ISO (lower)
setting.
•
Move light(s) farther away from your subject.
•
Adjust exposure compensation in the camera.
•
Adjust lighting power.
Photos are under-exposed (too dark)
•
Adjust aperture (larger), shutter speed (slower), or ISO (higher)
setting.
•
Move light(s) closer to your subject and make sure they are pointed
in the right direction.
•
Adjust exposure compensation in the camera.
•
Adjust lighting power.
Strobe(s) will not fire
•
Turn on strobe.
•
Check the strobe(s) battery life.
26
Advertisement
Table of Contents
