Download Print this page

Installation Instructions - Avantgarde LBWC-100S2 Instruction Manual

2 zones built-in wine cooler

Advertisement

Available languages

Available languages

3-PREPARATION & INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
Remove the exterior and interior packaging.
Before connecting the Wine Cooler to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door.
INSTALLATION DIAGRAM FOR THE BUILT-IN MODELS
● Level the unit inside the cabinet.
● Open the door of the unit at a 90°angle.
Installation of Your Wine Cooler
This appliance is designed for free standing installation or built-in (fully recessed).
Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded. To
level your Wine Cooler, adjust the front leveling leg at the bottom of the Wine Cooler.
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.).Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
Avoid locating the unit in moist areas.
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning about power and/or grounding should be directed toward a certified electrician or
an authorized products service center.
Reversing the Door Swing of Your Appliance
The door of this appliance has the capability of opening from either left or right side. The unit is
delivered to you with the door opening from the left side. If you desire to reverse the opening
direction, please call service center. (Fees will apply)
11/27/2009
15

Advertisement

loading
Need help?

Need help?

Do you have a question about the LBWC-100S2 and is the answer not in the manual?