Installation And Activation - Kidde 2070-VDSR User Manual

8. Installation And Activation

After selecting the proper location for your
alarm, attach the mounting bracket to the wall
or ceiling. To ensure aesthetic alignment of
the alarm with the hallway, or wall, the "A" line
on the mounting bracket should be parallel
with the hallway when ceiling mounted, or
horizontal when wall mounted.
(Figure 8-A)
•
Install the alarm fully on the mounting
bracket by rotating the alarm in a clockwise
direction. (Figure 8-B)
NOTE :
The alarm will mount to the bracket
in 4 positions (every 90 degrees).
•
Pull out the battery pull tab to activate the
battery.(Figure 8-C)
•
Battery activation is confirmed with a single
power-on chirp, and a voice prompt to "Push
Test Button."
•
If pulling the battery tab does not result in
the chirp and voice notifications, open and
close the battery compartment once.
Confirm power activation.
•
The alarm is now activated! After
installation / activation, test your alarm as
described in Operation and Testing section.
WARNING : FAILURE TO PROPERLy
INSTALL AND ACTIVATE THIS ALARM
WILL PREVENT PROPER OPERATION OF
THIS ALARM AND WILL PREVENT ITS
RESPONSE TO FIRE HAZARDS .
When mounting
in a hallway, the
"A" line should
A
be parallel with
the hallway.
Remove
Figure 8-A
Install
Figure 8-B
Battery
pull tab
PULL OUT TAB TO ACTIVATE BATTERY
SEE USER GUIDE FOR ADDITIONAL INFORMATION
Figure 8-C
Alignment Marks
("A" Line) on
Mounting
Bracket
When wall
mounting, the
"A" line should
be horizontal.
13