Installation And Activation - Kidde 3050-VDSC10 User Manual

Trusense smoke/co combo
Table of Contents

Advertisement

9. Installation And Activation

NOTE: One of the following steps must be taken to ensure activation:
A. Locate the red wheel on the back of the unit - turn the red wheel to
the "ON" position using the included white activation tool or a
standard screwdriver. Battery will remain active to allow for installa-
tion on mounting bracket.
B. Orient the unit with LED pointing to the right as shown in Figure
9-B, and rotate the unit a full 90 degrees clockwise onto the mounting
bracket. To allow for installation, battery will remain active when unit is
removed from mounting bracket.
NOTE: The battery activation is a one-time feature that occurs when
the alarm is rotated fully onto the mounting bracket. After activation,
the battery cannot be turned off, and can only be discharged at the
end of unit life. If the alarm is removed from the mounting bracket,
the battery will remain active. See Permanently Disable Alarm /
Discharge Battery section.
After selecting the proper location for your alarm, attach the mounting
bracket to the wall or ceiling. To ensure aesthetic alignment of the alarm with the hallway, or wall, the "A" line
on the mounting bracket should be parallel with the hallway when ceiling mounted, or horizontal when wall
mounted.
• Install the alarm fully on the mounting bracket by rotating the alarm in a clockwise direction.
Mark and drill two 3/16" (5mm)
The alarm is now activated! After installation / activation, test your alarm as described in Operation and Testing section.
WaRNING: FaILURE TO PROPERLy INSTaLL aND aCTIVaTE THIS aLaRM WILL PREVENT
PROPER OPERaTION OF THIS aLaRM aND WILL PREVENT ITS RESPONSE TO FIRE HazaRDS.
Alignment Marks
("A" Line) on
Mounting
Bracket
holes for wall anchors.
A
Figure 9 -C
Figure 9 -A
底盘
拆卸
按上面的图示,报警器对齐底盘"A"标记线,
安装到报警器到底盘上,顺时针旋转90度。
Figure 9 -B
When mounting
in a hallway,
the "A" line should
be parallel with the
hallway. When wall
mounting, the "A"
line should be
horizontal.
USE ACTIVATION
TOOL OR SCREWDRIVER
注意"A"
标记线的方向.
LED 指示灯
安装
15

Advertisement

Table of Contents
loading

Table of Contents