Remote Start Selectable Features; To Program The Remote Start Selectable Features; Programming Tach Rate - Audiovox Car Security System AX-900 Installation Manual

Audiovox car security system installation manual

Hide thumbs Also See for Car Security System AX-900:

Owner's manual (21 pages)

Table Of Contents

Table of Contents

Feature

Lts Flash 1X

1 RF Start Chirp

Off

2 Run Time

5 Min.

3 Park Lights

On Steady

4 Input Check

Voltage

5 Voltage Level

> 0.5V B4 Start

6 Ign. 2 Crank

Off

7 Diagnostics

Off

8 Crank Time

0.8Sec

9 Gas/Diesel

Gas

10 Trans. O/P

While RS On

11 Temp Start

Off

NOTE: When selecting Diesel operation, (Feature Nine), over gasoline, the only change is to the ignition circuits.

When Diesel is selected, the ignition circuits will power up 10, 15, or 20 seconds before the start circuit. The

intent of this feature is to allow the glow plug warming required by some diesel engines. If your vehicle is a

instant start diesel, it is not necessary to activate this feature.

NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and be certain

to connect the tach input wire.

To Program The Remote Start Selectable Features:

1. Turn the ignition key to the On position.

2. Press and release the valet/program switch three times.

3. Immediately turn the ignition key Off then press transmitter start button for 1 second.

4. Immediately turn the ignition key back On.

5. Press and release the valet/program switch two times. The siren will emit 2 short and 1 long chirp verifying you

are in the feature program mode.

6. Use button 1 on the transmitter to advance to the feature you want to change. EXAMPLE- If you need to change

selectable feature 3, press and release channel 1 button on the transmitter 3 times in succession. The parking

lights will flash and the siren will chirp 3 times confirming that selected feature 3 can be changed.

7. Use the start button on the transmitter to change the selection of the programmable feature. If you are not sure

what the setting for any feature is, press the start button one time; the parking lights will flash once or twice

indicating the features setting.

NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between steps, or the

programming mode will be terminated.

Programming Tach Rate:

NOTE: All applications require that tach be programmed.

The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start

without first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and

stored. If the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is

running and, in certain instances, may try to reengage the starter motor.

The Remote Start Unit will learn the tach rate of most vehicle's single coil, multiple coil packs, or single injector. To

learn tach.

1. Turn the ignition key to the On position.

2. Press and release the valet/program pushbutton switch 3 times.

3. Immediately turn the ignition key Off.

4. Press and hold the valet/program pushbutton switch; then start the vehicle using the key.

5. When the unit senses the tach signal, the parking lights will begin to flash.

6. Release the valet/program pushbutton switch. The parking lights will turn on for three seconds to indicate that the

learned tach signal is stored and the unit is out of the tach learn mode.