Removal And Replacement: Water Reservoir & Bin Controls - Scotsman NSE650 User Manual

NSE650
REMOVAL AND REPLACEMENT: Water Reservoir & Bin Controls
WATER RESERVOIR
1. Shut off the water supply to the icemaker.
2. Remove front panel and reservoir cover.
3. Disconnect water inlet line from float valve.
4. To remove float only, push in the locking tab
under the float valve, and pull float up and out of
the reservoir.
Note: an internal plunger is available separately.
5. To remove reservoir, remove drain hose from
reservoir.
6. Remove water level sensor from reservoir.
7. Remove evaporator inlet hose from reservoir.
8. Remove mounting screws from reservoir
bracket, and remove reservoir from icemaker.
9. Reverse to reassemble.
BIN CONTROLS (Ice Level Sensors)
FLOAT
ASSEMBLY
PLUNGER
LOCKING
TAB
1. Disconnect electrical power.
2. Remove front panel.
3. Remove control box cover.
4. Locate ice chute, at the base of the chute, in
front of and behind it are two plastic bin control
mounts.
5. Pull each bin control (ice level sensor) out of the
rubber mounting grommets, and in the control box,
disconnect the electrical leads connecting the bin
control to the circuit board.
6. Reverse to reassemble, be certain that the bin
controls are aligned so that the ice level sensors
are visible (centered) through the grommets in the
ice chute.
June 1994
Page 22
ICE LEVEL SENSORS:
SLIDE UP TO REMOVE