Removal And Replacement: Water Reservoir & Bin Controls - Scotsman NME1854R Service Manual

NME1854R & FME2404R
REMOVAL AND REPLACEMENT: Water Reservoir & Bin Controls
WATER RESERVOIR
1. Shut off the water supply to the Ice Machine.
2. Remove front panel and reservoir cover.
3. Disconnect water inlet tube from reservoir inlet
fitting.
4. To remove float valve, push in "locking tabs" as
shown and pull float up.
Note: The plunger/seat is available separately as a
part.
5. To remove reservoir, pull up and remove water
sensor.
8. Disconnect water outlet tubes.
9. Remove mounting screws from reservoir bracket
and remove the reservoir from the Ice Machine.
10. Reverse to reassemble.
SLIDE BIN
CONTROLS IN
AND OUT
FLOAT
ASSEMBLY
ICE
CHUTE
LOCKING
TABS
BIN CONTROLS (Ice Level Sensors)
1. Disconnect electrical power.
2. Remove front panel.
3. Remove control box cover.
4. Locate ice chute, at the base of the chute, in
front of and behind it are two plastic bin control
mounts.
5. Slide each bin control to the left, and in the
control box, disconnect the electrical leads
connecting the bin control to the circuit board.
6. Reverse to reassemble, be certain that the bin
controls are aligned so that the ice level sensors
are visible (centered) through the holes in the ice
chute.
January 2000
Page 28
Water
Sensor