Advertisement
Quick Links
PRELIMINARY WARNINGS
The word WARNING preceded by the symbol
risk. The word ATTENTION preceded by the symbol
instrument or the connected equipment.
The warranty shall become null and void in the event of improper use or tampering with the module or devices
supplied by the manufacturer as necessary for its correct operation, and if the instructions contained in this
manual are not followed.
WARNING: The full content of this manual must be read before any operation. The module must only be used by
qualified electricians. Specific documentation is available using the QR-CODE shown on page 1.
The module must be repaired and damaged parts replaced by the Manufacturer. The product is sensitive to
electrostatic discharges. Take appropriate measures during any operation.
Electrical and electronic waste disposal (applicable in the European Union and other countries with recycling).
The symbol on the product or its packaging shows the product must be surrendered to a collection centre authorized
to recycle electrical and electronic waste.
DOCUMENTATION
SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287
CONTACT INFORMATION
Technical support
This document is the property of SENECA srl. Copies and reproduction are prohibited unless authorised.
The content of this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
MI00620-1-EN
INSTALLATION MANUAL
Z-PASS2-RT
Z-PASS2-RT-S
Z- PASS2-RT
support@seneca.it
INSTALLATION MANUAL
indicates conditions or actions that put the user's safety at
indicates conditions or actions that might damage the
Product information
DOCUMENTATION
Z- PASS2-RT-S
sales@seneca.it
1/4
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Seneca Z-PASS2-RT
Summary of Contents for Seneca Z-PASS2-RT
- Page 1 The symbol on the product or its packaging shows the product must be surrendered to a collection centre authorized to recycle electrical and electronic waste. DOCUMENTATION DOCUMENTATION Z- PASS2-RT Z- PASS2-RT-S SENECA s.r.l.; Via Austria, 26 – 35127 – PADOVA – ITALY; Tel. +39.049.8705359 - Fax +39.049.8706287 CONTACT INFORMATION Technical support support@seneca.it Product information sales@seneca.it This document is the property of SENECA srl.
- Page 2 MODULE LAYOUT MOBILE ANT. ANT. Weight: 270 g; Enclosure: PA6, Black SIGNALS VIA LED ON FRONT PANEL STATUS LED meaning Device powered correctly Device not powered Locking system Flashing The module is working correctly System Locked / Booting Input or output activated DIDO1..DIDO6 Input or output deactivated VPN connection active...
- Page 3 TECHNICAL SPECIFICATIONS CERTIFICATIONS POWER SUPPLY 11 ÷ 40Vdc; 50 ÷ 60Hz; Max absorption: 6 W ENVIRONMENTAL Operating temperature: from -25°C to +65°C; Humidity: 10% ÷ 90% non condensing. CONDITIONS Storage temperature: from -30°C to +80°C; Degree of protection: IP20 ASSEMBLY 35mm DIN rail IEC EN60715 CONNECTIONS Removable 3.5 mm pitch terminal block, 1.5 mm...
- Page 4 In this case, the user may have to take adequate countermeasures. IDC10 CONNECTOR Power supply and Modbus interface are available also using the Seneca DIN rail bus, via the IDC10 rear connector, or the Z-PC-DINAL2-17.5 accessory. Power supply DC +...
Need help?
Do you have a question about the Z-PASS2-RT and is the answer not in the manual?
Questions and answers