For The Plumber - Scotsman FDE470 Service Manual

For The Plumber

Drains:
The dispenser requires a gravity drain. The pitch
on the drain tubes must be at least 1/4 inch fall per
foot of horizontal run. On long horizontal runs, a
vent at the back of the cabinet will improve
draining, and is recommended.
There are two drains to connect: A sink drain, a
7
" plastic tube; and the bin drain, a
5
" plastic tube. Install rigid tubing between the
machine and the building drain. Route the
drains separately to the building drain.
Water supply:
Connect cold, potable water to the machine. A
hand valve near the location is recommended. A
water filter is also a good idea.
Follow all local codes.
Water Supply
Water Inlet Fitting
(Inside Cabinet)
Strainer or
Filter
Bin and
Reservoir
Overflow Drains
August 1994
Page 5
8
8
FOLLOW ALL APPLICABLE LOCAL,
STATE AND NATIONAL CODES
Sink Drain
Building Drain
(Typical)
FDE470