Inflating Instructions; How To Use Boston Valve; Seat Installation - Intex Excursion Pro K1 User Manual

Inflating Instructions

Before starting, locate a clean area free of stones or other sharp objects. Unroll the
kayak so it is laid out flat, and locate your pump.
Use a hand or foot operated air pump to inflate the boat. Do not use high-pressure air
compressors. Adults should inflate the chambers following the numerical sequence marked
on the valves. It is very important to follow the numerical sequence; failure to do so will
result in an improperly inflated boat. Fill each chamber until it is stiff to the touch but NOT
hard. Use the enclosed ruler to check the main chamber for proper inflation. DO NOT OVER
INFLATE. Fill with cold air only.
IMPORTANT: Air temperature and weather condition do affect the internal air pressure of
inflatable products. In cold weather the product will lose some pressure due to the fact that
the air will contract. If this occurs, you may want to add a little air to the product. However, in
hot weather, the air will expand. You must let some air out to prevent the product from failing
due to overpressure.

How to Use Boston Valve:

1. Double valve cap (valve lets air in, not out).
2. Quick deflation cap.
3. Unscrew Double valve cap.
4. Insert output end of air pump into valve and fill. Do not over inflate or use high pressure
compressor.
5. To deflate: unscrew quick-deflation cap. CAUTION: Double valve does not operate when
this cap is off. Do not unscrew this cap while boat or inflatable is in water.
1
Seat Installation (Certain Models):
1. Inflate each seat cushion slowly to about 75% of its capacity.
2. Finish inflating the seat cushions slowly until it is firm to the touch but NOT hard. DO
NOT OVER INFLATE!
3. To disassemble the seats, deflate the seats first and reverse the installation procedures.
4. Some seat cushions after inflation are tuck in directly into the fore, mid or aft locations
of the kayak cockpit.
Grab Line Installation (Certain Models):
IMPORTANT: To properly install the inflatable boat's grab line and/or accessory lines, first
inflate the boat. If is necessary, begin the grab line installation at the rear of the boat by
threading it through the rope holders completely around the outside of the boat. Tie the two
loose ends in a square knot at the rear end of the boat.
For Explorer kayak series, make sure the grab line is threaded
through the rope holders completely on the outside of the boat,
even after the rear or front cover is removed. The grab line
shall be attached to the boat at all time.
SAVE THESE INSTRUCTIONS
(94PO) "NMMA" KAYAK ENGLISH 4.875" X 7.25" 05/19/2021
3
2
Page 6
4
5
Square knot
94
PO