Inflating Instructions; How To Use Boston Valve; Fishing Rod Holder Use - Intex 68367EP Owner's Manual

(93PO) "NMMA" BOAT W/O MOTOR MOUNTING (TYPE I) ENGLISH 4.875" X 7.25" 05/13/2019

Inflating Instructions

Before starting, locate a clean area free of stones or other sharp objects. Unroll the
boat so it is laid out flat, and locate your pump.
Use a hand or foot operated air pump to inflate the boat. Do not use high-pressure air
compressors.
Adults should inflate the chambers following the numerical sequence marked on the valves.
It is very important to follow the numerical sequence; failure to do so will result in an
improperly inflated boat. Fill each chamber until it is stiff to the touch but NOT hard. Use the
enclosed ruler to check the main chamber for proper inflation by leveling it with the gauges
printed on the boat. DO NOT OVER INFLATE. Fill with cold air only.
IMPORTANT: Air temperature and weather condition do affect the internal air pressure of
inflatable products. In cold weather the product will lose some pressure due to the fact that
the air will contract. If this occurs, you may want to add a little air to the product. However,
in hot weather, the air will expand. You must let some air out to prevent the product from
failing due to overpressure.

How to Use Boston Valve:

1. Double valve cap (valve lets air in, not out).
2. Quick deflation cap.
3. Unscrew Double valve cap.
4. Insert output end of air pump into valve and fill. Do not over inflate or use high pressure
compressor.
5. To deflate: unscrew quick-deflation cap. CAUTION: Double valve does not operate when
this cap is off. Do not unscrew this cap while boat or inflatable is in water.
2
1
Fishing Rod Holder Use (Certain Models):
1. Slide the end cap over the end of the fishing rod.
2. Insert the fishing pole into the holder.
SAVE THESE INSTRUCTIONS
3
Fishing
Rod
Page 6
4
5
Fishing Rod Holder
End Cap
Fishing Rod
93
PO
Holder