Samoa 383 401 Parts And Technical Service Manual page 4

EN
BUTTONS FUNCTIONS
Back/Cancel
Power/Select
Navigation keys (Up/Down)
Navigation keys (Left/Right)
CONFIGURATION
PAIRING THE U·VISION
The U·vision can be paired with a U·meter
+
U·count device.
Press Power button (Fig. 1) during a short time. In the left
bottom part of the screen, you will see the current
U·vision firmware version.
+
U vision
FW 1.04
Fig. 1
NOTE: make sure that the U·meter
Follow the below instructions to pair your U·Vision
1. Starting from the connecting screen (Fig. 2) press the
Power and Back button at the same time button until
U·vision shows "SETUP" (Fig. 3) on the screen. Release
+
the buttons.
SETUP
Fig. 3
3. To select the reel you can use the Up and Down buttons,
and press the Power button when the hose reel number
is correct.
RESTARTING...
Fig. 5
4
838 856 R. 06/23
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
+
WITH A FLUID MANAGEMENT DEVICE
, U·valve or
+
001
+
SAMOA
, U·valve or U·count device is powered on before pairing the U·Vision
+
001
001
OK!
Then the U·vision
connecting screen (Fig. 2). This screen will disappear after
a few seconds if the U·vision
but if it has not been paired then the message will stay on
screen waiting for configuration.
Fig. 2
:
+
2. Then, the configuration screen is shown automatically
(Fig. 4). The U·vision
reel number you wish to associate.
HOSE NB.:
Fig. 4
4. Once the reel number has been set, the display shows that
the configuration has been accepted and the gun restarts
(Fig. 5). Depending on U·track configuration, the screen
will show "Normal Mode" or "Updating Work Orders".
PRODUCT
Fig. 6
will try to connect and will show the
+
has already been configured,
+
CONNECTING...
is now waiting for you to enter the
+
[ 1]
?
READY!
✓
001
.
+
001
001